DIY Path Maker Paver Molds Stone Brick Concrete Mold Concrete Cement Walk Garden Path Paving Paver Reusable Patio Molds Paviment

9 Grid Garden Pavement Mold Garden Walk Pavement Concrete Mould DIY Manually Paving Cement Brick Stone Road Concrete Molds
Specifications:
Material: PP resin
Irregular size: 35*35*3.6cm/13.77*13.77*1.41''

Instructions:
step 1:
Mix the cement with water according to the packing instructions. When ready for use, the concrete will be the consistency of the oatmeal and thick enough to hold the edges when cut with a shovel.
Step 2:
Fill the paver mold, plow the concrete with a shovel and make sure to fill each area.
Step 3:
Use rubber gloves to spread the concrete around the mold and fill any gaps or low points. Tap the mold by hand to remove any air bubbles.
Step 4:
Smooth the concrete according to the CONTOUR of the mold and wipe off the excess.
Step 5:
Allow the concrete to set up to five minutes and carefully remove the mold. For the next stretch, rotate the mold a quarter turn and place it next to the paver you just finished. If you are creating a curved path, tilt it slightly.
Step 6:
After allowing the concrete to solidify overnight, fill the crack with dirt and rinse off the excess. Wet the ground around the newly formed paver to help them settle.

Notes:
Please allow 1-3mm differs due to manual measurement.
Due to the different display and different light, the picture may not show the actual color of the item. Thanks for your understanding.